7 Comments

    • Hey Alex,
      I’m planning to make the whole thing – you’ll see part of the shell in the upper half of the photo. I don’t yet know if it’s going to hold itself together though! I think it’s got about a litre of various different glues in it already, hehe.

  1. Kanto fan

    Also what’s next after lapras. Are you going to finish up the unovoa starter or move on to a new regions starters? Whatever it is I’m lookin forward too it (and be sure to take abreak here and there 🙂 )

    • Hm… It’d be nice to finish off the Unova starters before X and Y come out, but at my current rate (slow) I don’t think I’ll manage it.

      I have a Mewtwo design almost ready to go, but whether or not I attempt it is going to depend on how the Lapras turns out. I might have to rework the templates because what I’m learning with Lapras is that pasting down a large sheet of paper and getting it to line up is hard!

      Thanks again for your encouragement and enthusiasm 🙂

    • Hi, sadly I haven’t had any time to work on any new models. I did mostly complete Lapras however and I’ll have to see if I can find some photos of it to share. Making something that large had a few new engineering problems to tackle and I guess it would be worth sharing what I learned.

  2. Gary mofo oak

    Hey Althea! How’s the work on lapras and mewtwo. I’d love to give them a shot if you
    Could share the models with me
    Thanks

Leave a Reply to Gary mofo oak Cancel reply

Your email address will not be published. Required fields are marked *